about 6 mths ago we had a dead short on batt cables. Since then we have replace: starter, alt, new batts, batt cables and have done cks on fuses. The pkup has power to the system but will not turn over. We hear clicking like the cellinoid in starter working. We have hit a wall. Any ideas would...

Hello, we are near Cairns and have a 1990 PZJ73 5 cylindar medium wheel base cruiser we are looking to sell. As this is a rather unusual model, can anyone recommend a good place to list this car? if anyone also has a resource I can use to find a value on it, that would be great. Many thanks, chris

Anyone care to give me their thoughts on Old Man Emu suspension systems. My hopes are for a better ride on rocky and rutted roads with no intentional, or extreme, rock climbing. Thanks Bob Walker

check engine light on will not go over 2500 rpms acts just like a rev limiter, apply gas and steady in time surge between 2100 and 2500 rpm. exhaust free flowing major tune done 8000 miles ago.

HELP!!! I am trying to rebuild my spicer 44-8FD front axle on my 87 Dodge W150. I am comfortable around tools and don't mind getting dirty... however I cannot seem to get the ring and pinion free from the housing. I have removed the bearing caps, pried, pulled, smashed, etc and can't seem to get...

I am trying to find an engine and tranny for my 86 nissan so I can experiment with bio diesel. anyone out there know where I can look.

I'm looking for front tow hooks for an '02 dodge ram 1500. Mopar has a bar with 2 hooks for the front of '03's on up, but they say it doesn't fit an '02! Thanks, Jerry Check email address if replying directly.

Engine is 4.3L V6 Vortec fuel injected. Does anyone have a list of the diagnostic codes? Can't seem to find them in the Haynes manual. Any help would be appreciated.

WTB: Factory spare tire mount for underbed of 1997 Ford F-250 4x4, 8' bed. Any of you guys who've jacked up your truck "baha" style and have your spare mounted to the rollbar and want to get rid of the factory mounting bracket, please respond. Prefer clean, usable parts, no rusted out...

I've got an '87 Samurai with humble mods (tires, catback, headers, cage). It hasn't been driven much in the last 5 years, but now it's my daily driver in addition to fun adventure vehicle on the weekend. I've got an idle problem. Either it's racing at 3,000 or stumbling along at less than 1,000...

I need to find a new (good condition) bench seat or bucket seats for my 85 toyota 2w drive longbed. I have looked but was unable to find any. Any suggestions???

My 1986 F250 clutch does not disengage completely. What needs service, replacement? Why? The transmission is 4sp, clutch is hydralic. The hyd resovoir is full. There are no leaks at the master or slave. Peddal "feels" normal both in compression & release, not too soft or hard. The clutch doesn't...

I would like to install headers and dual exhaust on my 1995 GMC Sierra 2WD 350. I've been told this will hinder my performance, gas mileage and power. Any truth to this or will this installation actually improve these things?

My truck started ideling rough and engine light came on. I had it scanned and the code was a misfire on cyl. 5 I have replaced the plugs, wires, cap, rotor, pcv valve, and fuel filter. It is still running rough till about 2000 rpm and engine light is on . I had it scanned again and came up with...

Hi, I am buying a used Nissan Xterra XE V6 4x4 2003 Model. I noticed that the front wheels had the Hub cap (The one which says "Nissan" on them). But the rear wheels don't have that. Does anyone know if that was the default for that model ? Thanks !

Hello to all For those wanting to get rid of the gas engines in vehicles up to 6 ton GVW this may be the cure. 2.8 Lt turbo charged intercooled 135 HP, 277 ft pounds of torque at 1400 RPM. We have people putting these in Land Rovers, Jeeps, Ford and GMC. will also replace the gas eaters in Dodge...

hey, i'm getting a 1985 nissan truck from my grandpa, the truck runs great but the tailights dont work and neither do the blinkers, its some electrical problem i guess but i dont to where to begin fixing it. i checked the fuses qand they seem fine. the headlights work, the running lights work. do...

Hey fellas I have a 98 Ranger 4x4 that came with 235/70/16 tires. I have a chance to pick up 4 new 245/75/16 for a really good price. Will these tire work on my Ranger? I would like to know before I purchase them and find out they won’t fit. Thanks, Erick -- Posted using the...

When I manual shift to neutral coming to an intersection or stop, my 93 wrangler 4.0 FI engine sometimes stalls out. It seems to have coincided with my speedometer not working. Would that be a cause? I disconnected the connector leading to the sensor/gear on the transfer case and I noticed a three...

I have a 86 Nissan and after driving for a while and then letting it idle for about 5 minutes. This causes it to smoke, but once it gets going again it is fine. The color of the smoke is blueish white. I'm thinking extra fuel but not sure. Any help?