A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Clear plastic lense repair by leadlap24
Hi my name is Hal and I just found your site, and from what I have seen this is the place for information!, so here is my question, I have a pair of 45 year old, once in a life time clear plastic lenses that need to be restored, the lenses are not missing any pieces and are still very clear, but...
June 30th 06 02:33 AM
by Paul Go to last post
2 130
94 Grand Prix starts but stalls by [email protected]
My 94 Grand Prix starts, revs up to about 3000 rpm, and stalls withing a couple seconds. I've got fuel and spark, but it still stalls. Mass airflow sensor, or maybe O2 sensor? Can someonepoint me in the right direction? Thanks for any help/info. Tim
June 30th 06 01:50 AM
by gfulton Go to last post
9 204
1995 Nissan Quest interior light by [email protected]
I think that my Quest needs a new TIME CONTROL MODULE which controls the interior lights. The lights won't turn off when you shut the door. I 've been told that it is a black and green box about 3X5X1" and is under the dash on the drivers side. I can't find it. I even went to the junk yard and...
June 30th 06 12:50 AM
by [email protected] Go to last post
0 122
Lens Cover came off Parking/Turn Lamp by [email protected]
Seems like the easiest way to put it back on would be Epoxy. Good idea? Better idea?
June 29th 06 11:48 PM
by [email protected] Go to last post
3 110
caliper movement by [email protected]
Are calipers supposed to move freely once it's fitted? GM service manual says "The brake caliper should move easily within the brake caliper bracket" I'm not sure about this though...once the caliper bolts are tightened, I sure can't move the caliper! The same with the original fittings...they were...
June 29th 06 06:32 PM
by [email protected] Go to last post
3 119
1995 Ford E350 RV 460 Pre-detonation Problem by dabworth
The truck has 15000 miles on it and has been thru 3 engines due to pre-detonation. Timing is correct but jumps around a bit, have verified chain to be OK. has new distributer and pickup, ICM checks OK, Ive been thru idle air , map & 02 sensors , any ideas what else could cause this condition...
June 29th 06 03:10 PM
by thecombustionkid Go to last post
1 167
Rattling Noise in '94 Jeep Grand Cherokee by [email protected]
Hello, When my Jeep (130,000 mi.) is in park, or moving very slowly, I here a rattling/clicking sound. Any ideas as to what it may be? Thanks in Advance!
June 29th 06 02:22 PM
by Mike Romain Go to last post
1 140
Car buying advice wanted! by Paul
Car buying advice wanted! I kind of like the following models - These are approximate RANGES available in my area. I've looked them inside and out but have not driven them except for Chevy Classic rental cars. I'll be doing all my own work on them. 03 Infiniti G3.5, 2dr, $20k, 50k miles 05 Mazda...
June 29th 06 03:56 AM
by [email protected] Go to last post
4 155
Airbag warning oddity by Jim Beaver
I've got a 2005 Dodge Magnum. I just had the passenger-seat airbag warning monitor recalibrated because the warning light/chime was going off and on every minute or two whenever the passenger seat was empty. The technician told me something about the monitor getting all discombobulated if I put...
June 29th 06 02:55 AM
by Kevin Go to last post
6 105
Mazda 626 (year 2000) and the automatic transmission liquid replacement by BDay
Hi, I have a Mazda 626, year 2000. I'd like to know if the automatic transmission needs a liquid replacement and if yes, after what period? Best regards, Badrday.
June 29th 06 01:24 AM
by Charles G. Hill Go to last post
2 176
1994 Buick Regal by kelshawmic
I recently have been noticing that my battery gauge has been going down drastically to about 9-10 with everything on (turn signals, radio, headlights, etc.). But when everything is off- the voltage goes back to 13. So I got a new alternator and had the battery charged up for about 10 minutes....
June 29th 06 12:54 AM
by Paul Go to last post
2 151
AUTO AC suction pressure low by Jeff
I have an '88 New Yorker that has been converted to 134. I've vacuumed out the system and added two cans of R134, this worked fine for a while but stopped cooling after 15 minutes. System is still charged. Looking at the suction side I see a vacuum, this slowly goes away after a minute and the AC...
June 29th 06 12:36 AM
by philthy Go to last post
6 139
QUESTION: 1996 Ford 4.6L Intake Manifold by EADGBE
I have a 1996 Ford Mustang GT with the 4.6L V8. My car's engine had the famous junky intake manifold that leaked coolant. About 2 years ago I bought an aftermarket intake with the improved design and installed it myself. The intake fit perfectly and worked perfectly...with NO leaks anywhere. I was...
June 29th 06 12:18 AM
by philthy Go to last post
2 177
please stop! TV shows reinforcing bad habits... by Nate Nagel
currently watching "Trucks" on Spike while looking online for parts for my '55 STude project... I swear they've had at least 3 or 4 shots of someone tightening down a nut with an impact wrench in the last 5 minutes! Impacts are for loosening, torque wrenches are for tightening. come on...
June 28th 06 09:37 PM
by N8N Go to last post
7 147
When Fan on HI spd, AC Compressor Clutch releases...? by loadhawg
When Fan on HI spd, AC Compressor Clutch releases...? 90 Nissan 240SX w/ factory AC - the HVAC fan has 4 speeds + off. Using the fan at up to speed 3: AC does a pretty good job of keeping the car cool almost up to triple digit temps outside. Once outside hits 100+ it can take a while to cool car...
June 28th 06 03:19 PM
by DaveC Go to last post
5 134
FIAT 128 PROBLEM by mitbaq
June 28th 06 02:38 PM
by Mike Romain Go to last post
1 128
Need exhaust by m.c
Anyone know of reasonable place to go? Located in Dallas area. Have 86 Chevy truck, nothing beyond manifolds. Need catalytic converters and mufflers to pass inspection
June 28th 06 10:39 AM
by m.c Go to last post
0 105
Sanden SD-508 repair manual? by DaveC
Sanden used to have a maintenance manual for the SD-508 compressor on their web site but it's since been replaced by one for the later series that differs in many ways. Anyone have a 508 manual downloaded from the Sanden site long ago they'll send me? Thanks, -- DaveC
June 28th 06 08:19 AM
by DaveC Go to last post
0 130
1999 honda accord transmission oil leak by ahsanul
I'v got a 99 honda accord and I found that the transmission fluid is leaking on the parking lot and the transmission fluid level is dropping. I first realized it after the check engine light came with OBD error code 0740. Took the car to Aamco transmission, told me that I need to replace the trany...
June 28th 06 04:06 AM
by M.M. Go to last post
2 123
Pontiac Vibe (2003) by lionheart
Have two questions that someone might be able to help me with. 1. How to change the bulb behind the dash panel the lights up the temp knob. Would like to change it myself but don't know how to remove dash panel in front of it. 2. Have been hearing a clicking noise behind the dash. Almost sounds...
June 28th 06 12:57 AM
by lionheart Go to last post
0 139
Post New Thread

Display Options
Showing threads 10001 to 10020 of 16756
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 09:11 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 AutoBanter.
The comments are property of their posters.