A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : VW air cooled Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
* * * * * * * All Bloggers Go Here * * * * * * * by [email protected]
http://www.are-u-sure.blogspot.com <- - - all bloggers go here
March 9th 05 04:27 AM
by [email protected] Go to last post
0 646
z bars on 67-68 beetle by Scott S
Does anyone have a diagram or a picture showing an assembled Z bar on a 67 or 68 beetle? I have a bag of new rubber and slides on the floor and two naked rods on the car. Any help appreciated. Scott
March 9th 05 04:50 AM
by Scott S Go to last post
0 396
Idle jet on Brosol 30/31? by Phatman
Hi, Another Brosol 30/31 question! I didn't get any literature with my carb and I was wondering which jet is the idle jet - is it the one nearest to the bowl? TIA, --Steve
March 9th 05 02:57 PM
by Phatman Go to last post
2 463
Bug headlight rings - are they supposed to be plastic? by Remco
Hi All Slowly but surely, I am collecting items to use for later. Last week I bought headlight rings since mine are pitted. In reality, I won't use them for quite a while. The ones I bought were described as being for a "1969 VW Bus or Bug Eyelids, Original , chrome finished , excellent...
March 9th 05 03:48 PM
by Remco Go to last post
5 671
OT Fainting goats by Shag
I learned something new tonight. Yes, I think this is about as off-topic as you can get... http://www-personal.umich.edu/~jimknapp/goats.html --- "There's nothing wrong with a little shooting as long as the right people get shot." - Inspector Harry Callahan
March 9th 05 08:55 PM
by Matt S Go to last post
3 649
John S Henry of thebugshop.org - where have you gone? by OldIron
Hello there I was curious if anyone knew the new e-mail address for the man who created this site: http://www.thebugshop.org/ His e-mail me link to is dead. Thanks in advance! OldIron
March 10th 05 02:06 PM
by Rob Amos Go to last post
1 769
over rider plugs by Shawn
Hi gang!!! Anyone know where i can get plugs to fill in the over rider holes on a 67 beetle? rubber, billet, doesnt matter.....thanks!! Kath Jacobs....you still out there? Shawn East
March 10th 05 02:15 PM
by Shawn Go to last post
2 540
Super Beetle frame repair question by OldIron
Hello I have a '73 vert with a torn lower Frame head. Has anyone ever replace the lower framehead or know some that has? Thanks for any advice OldIron
March 10th 05 02:43 PM
by OldIron Go to last post
2 700
Some things never change........... by John Henry
You guys crack me up..... The "Shag topics", the "Jan answers", John Conolly, etc. RAMVA is still the same, nothing really changes. Idle moment, reading my RAMVA (don't do that much at all lately) haven't finished my 'cube yet (Jan, remember?), can't go to bed just yet..... Hope everyone is...
(Multi-page thread 1 2)
March 10th 05 05:03 PM
by TerryB Go to last post
11 1,036
Hmm... If only I could somehow do something similar again... :-) by Shag
COOL bug adventures! Inbox Hey there, wanted to let you know that I ran across your website two days ago and REALLY enjoyed it! Very entertaining, and quite helpful in my (hopefully) upcoming baja adventures. Actually, your website is the ideal website for me at this point. Currently all I...
March 10th 05 05:22 PM
by Joao Eliseu Go to last post
1 546
two bolts left by tricky
Hello all Just about got my body free on the 1303. Lots of grinding and unwelding - the body has been welded to the floor almost completely over the years !!. Anyway, I have removed all the bolts except 2. on the superbeetle site it says there are under the back seat, 4 13mm bolts and 2 17mm...
March 10th 05 06:14 PM
by TerryB Go to last post
6 646
He's BAAAACK...sort of OT by Mike C.
Don't recall if this was posted before, but everyone's favorite Disney bug is bag and updated for the new millenium. http://disney.go.com/disneypictures/herbie/ Mike
March 10th 05 06:21 PM
by P.J. Berg Go to last post
8 838
rusty bolt hint; by BananaRepublican
Planning some work on old bolts?. weeks before , squirt some thin oil on the bolts/nuts. I thin used motor oil and keep in squirt can. the vibration of normal driving helps the oil penetrate. good luck. > g adds; "Pay no attention to the naked gay conservative male prostitute sitting in the...
March 10th 05 11:13 PM
by BananaRepublican Go to last post
0 432
best place to find used 100hp engine by [email protected]
I'm looking for a ready to run (all accessories) type 1 used engine for use in testing an aircraft propeller. I would like to get 100hp at around 3500 rpm (I'll have a gear reduction so my prop speed will be lower). I don't need a rebuilt engine as this will just be run on a test stand. I'm not...
March 11th 05 12:18 AM
by P.J. Berg Go to last post
1 636
63 vw does rust bullet work like it says? by mojobutter
i’m planning on painting my 63 beetle.there is surface rust on the underside.i was wondering if anyone has ever used rust bullet.i dont really want to sand blAst it if there is another way.any advice for perhaps a better product or if i’ll have to jaust sand blast it would be greatly...
March 11th 05 04:41 AM
by Joey Tribiani Go to last post
1 362
Dirty Knuckles by TerryB
I have finally took a step into my bug engine. After the motor sitting in my shop, since last summer, collecting saw dust. I decided last night to go start the process of tearing into it to check the compression ration and fix a couple things that need attention. With temps in the 40's, it was...
March 11th 05 06:35 AM
by dragenwagen Go to last post
4 535
P.J. and James - you guys ROCK! by [email protected]
You guys are so cool for posting that you were having trouble accessing our site! I contacted our server and we are working on some little things that could be causing the problem. I wouldn't NEVER have known about these problems without your help! It all seems so weird. . . I mean it works for...
March 11th 05 04:32 PM
by [email protected] Go to last post
0 613
engine stuck to tranny by T & L
From: "Briantelope" > Subject: engine stuck to tranny! ugh! Date: Monday, February 21, 2005 10:49 PM 56 hard top oval, if you don't remember (you probably don't) Removed everything, and pulled the body off the pan. Feeling awesome. To keep myself busy during the week, I was...
(Multi-page thread 1 2)
March 11th 05 05:48 PM
by TerryB Go to last post
18 1,158
FA: Removing Fixed Windows by Mel P.
It's been six years since I took out the rear windows. Even so, I cut the rubber since I was replacing the seal. What's the easiest way to remove the windows and still be able to use the seal again? tia, -- Mel
March 11th 05 06:28 PM
by Alan Nelson Go to last post
2 669
Scams Abound... by John Willis
We still have our 1974 Thing for sale and there are a couple of ads out there that people occasionally come across. How many red flags can you spot in this request I received yesterday? (I didn't bother with a reply, for obvious reasons...) Hello Owner, My Name is wilson, I saw your advert...
(Multi-page thread 1 2)
March 12th 05 12:04 AM
by vic20owner Go to last post
11 741
Post New Thread


Display Options
Showing threads 1001 to 1020 of 6207
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:55 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.