was wanting to know if it is bad to spray the u-joints on the drive shaft with wd-40 or with other lube sprays? i have a 99 S-10 ext cab with 32,000 miles and i spray things down to keep things from rusting and i even sprayed the parts outside the transmision including the u-joints. is this not a...

Hi, I'm looking at the Honda CRV, Subaru Outback and the Xterra cars. I like the looks of the XTerra and the fact that it comes with a V6 engine. My convern is the 4WD. I read an article that the the XTerra has to be taken out to 4WD on dry pavement, or there will be excessive wear on the tranny....

Are'nt they make new one or not anymore? ~~Howard~~

What do you think about installing only coil spring spacers with the standard suspension (Toyota LC 90 series). Thanks. A.Mateus

I have a totalled Crown Victoria Police Interceptor with a good 4.6L engine and low miles on it. I was wondering has any successfully swapped this engine into a jeep? If so, what kind of transmission and transfer case was used? Thanks. Rob

& very Clean...........

I have a 1957 Willys 4x4 truck with only 46K miles and thinking about tricking it out to show. My 1990 Cherokee LIMITED EDITION with only 120K needs to go for the funds to do the Willys. Located in the San Francisco Bay Area.

Power Steering Pump Block Wood Trim Interior Cap rear window glass no cracks! and much much more I am parting out a 1983 Bronco with the 351W Email me with any parts

I plugged a power inverter into one of the power ports in my 2002 Suburban and immediately all of the power ports went dead. The regular cigarrette lighter worked, but the two power ports in the dash under the radio and the one on the back of the console don't. It wasn't obvious from the...

I have Hyundai Galloper 2.5 td 88 Hp and tires 235 75 R15(19"). I need to buy some tires for winter and my choice is wrangler mtr but only question mark is size. I dont know when I put 31" tire will my galloper have enough power in mud and snow

I am looking for advice on purchasing a truck. I am looking to get a well used Ford F150 or 250 truck and use it for Plowing 2 600 foot driveways and some minor hauling. This would be strickty a work truck and I would not be putting any real miles on this vehicle. I have several coworkers that...

I was wondering if anyone had off-road tire recommendations for a 1996 Ford F350 with a 7.3 Diesel. My application is truthfully all-purpose, but with a very heavy weight towards off-road mud, steep inclines, and in particular...snow. I do take the truck to home depot, etc but I couldn't care any...

Hi Does anyone know the mileage intervals when the cam belt(timing belt-chain) should be changed on a shogun 1998 3ltr V6. Thanks Regards Jeff

does anyone know where I can purhase a new dash for my 98 dodge ram, the dealer is just to expensive

I have a 94 Grand Cherokee with the Infinity gold stereo, i don't have the manual for the stereo. So i was wondering if somebody could email some instruction on how to do the radio pre sets. Also does anyone have a Infinity Gold stereo manual they would like to sell? Thank you

With the Labor Day holiday behind us, it's time to get to work! There are only 4 days left in the comment period regarding the proposed OHV rules for the national forests. ARRA encourages you to submit your comments by clicking the...

Will a set of 31x10.50 15's fit on a Ford Ranger/Mazda B4000 4x4 without Lifts/Fender trim? I have a set from an older (Japanese-built) Mazda, and my Brother wants them for his B4000, but we don't want to go to the trouble/expense of mounting them if they are not going to fit. Thanks. -Cyberbilly

My wife has recently fallen in love with the Land Rover Discovery (because she likes the way they look - she wants to sit up high). The research I have done on-line seems to indicate that these vehicles are unreliable, in that they need a lot of maintenance, and that that maintenance is expensive....

I have been thinking about upgrading my '54 1/2 ton to 4 wheel drive. 235 engine SM420 tran. Like to get stuff to bolt up. Can weld pretty good. Also upgrade to 3/4 ton axles. Plan to keep the original engine. Has anyone done a similar change. Any thoughts on tranfer case. Thinking a NP205. ...

I'm looking for a set of Lund (coldfront) winter grille inserts for my '89 Cherokee. Lund discontinued them for the Cherokee but I was wondering if anyone might be looking to get rid of a used set. I would even accept a partial set (at least 3) if some one's got one for sale.