A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Mazda Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Time to get a Sonata! by XS11E[_1_]
WOW, who'd a thunk it? http://www.azcentral.com/arizonarepublic/local/articles/1206speeder1206.html
December 8th 06 02:20 AM
by pws Go to last post
9 435
motor is out! by peter
after a couple stray wires and a stubborn heater hose, the power train came out. my cherry picker is pretty big and as i was pulling the unit out i was hoping i had enough room to clear the car. it is resting on a 2x4 next to the car. next, tranny to the shop to be checked out and strip to a...
December 7th 06 07:26 PM
by peter Go to last post
0 286
trouble extracting header... by peter
hi, i am ready to lift the motor out but i cant see how to remove the header. (jr i believe), and i am concerned about crushing it. i have even tried to pull the steering column but dont see how to release the rod from the rack. im really stick and would like to get this done today as it is...
December 7th 06 07:22 PM
by peter Go to last post
2 213
Battery died by Frank Berger
Just for the record: My OEM Panasonic AGM battery lasted 5 years. So did the Westco replacement.
December 7th 06 03:47 PM
by Frank Berger Go to last post
6 366
short block source by peter
anyone know where i can check out short blocks? thanks, peter
December 7th 06 02:34 PM
by peter Go to last post
0 446
replacing rubber deck lock sheets on hardtop by Don[_7_]
I have to replace the rubber seals on the two chrome assemblies that go over the Frankenstein bolts. I have the two new parts and they have rubber extrusions that go into holes on the bracket to hold the gasket in place. However, I have no information on whether some form of glue or sealing...
December 5th 06 02:01 PM
by mickey53usa Go to last post
1 232
WTB 2006 MX 5 by chance
WANTED TO BUY: 2006 Mazda Grand Touring, 6 Speed Trans. Suspension Package and Preferred Equipment Package a PLUS. Must be low mileage or a new dealer leftover and be in excellent Condition. Don, Grove City, Pa.
December 5th 06 05:30 AM
by chance Go to last post
0 214
Coolant boiling off in overflow by [email protected]
OK, I couldn't find anyone with exactly this problem, so I thought I'd post. I have a 1994 Miata with 155k miles. I live in North Central Texas. I noticed that my coolant overflow was showing up low or empty rather frequently, with none of the usual signs of coolant leakage, etc. I then noticed...
December 5th 06 04:12 AM
by BRUCE HASKIN Go to last post
3 635
Brake and Rotor questions by [email protected]
I have searched the past posts but still have some questions. What is the avg mileage for brakes and rotors before they need replacing? I realize this varies but is there a ball park number? Is it better to do the rear first or front first or does it even matter? Does the type of rotor matter? ...
(Multi-page thread 1 2)
December 4th 06 03:26 PM
by miker Go to last post
11 741
Mazda Miata parts dealer online? by my_two_cent
I have a local Mazda dealer that refuses to sell me simple parts without ordering them. The excuse is that they don't have the parts in stock, but I'm sure their own mechanics have everything they need. The last straw was when I asked for four bolts, the kind on the transmission pan and many other...
December 4th 06 01:05 PM
by Leon van Dommelen Go to last post
5 574
motor update and question by peter
hi after not being able to remove the ppf, i decided to remove the "cando" exh...the bolts too rusty to properly fit either double wretches or sockets, saws-all was too difficult to use, heat didn't help...three hours later, ahh die grinder :) i could now get my impact gun onto the drive shaft...
December 4th 06 10:50 AM
by peter Go to last post
0 216
2001 Horn Replacement Info by Karl North
Hello All, Maggie Mae (My '01 Miata) and I have been getting along quite well as of late. We just drove from South Louisiana to Flagstaff Arizona and back. That was a beautiful and truly enjoyable trip. I have been doing quite a bit of research on replacement horns. I decided against air...
December 4th 06 06:34 AM
by Natman Go to last post
1 227
Mazda adds first power hardtop to MX-5 Miata roadster by [email protected]
http://www.ng2000.com/news.php?tp=mazda It's that time of year when dark clouds and cool winds of winter prompt owners of the sprightly, two-seat Mazda MX-5 Miata convertible to start to put away their cars until the following spring.
(Multi-page thread 1 2)
December 4th 06 02:20 AM
by Iva Go to last post
15 1,225
"MazdaSpeed 3 sizzles" by Mike
MazdaSpeed 3 sizzles at http://www.washtimes.com/autoweekend/20061130-122646-1724r.htm
December 3rd 06 05:20 AM
by pws Go to last post
3 370
Salvage Yard in Houston by Thomas Misek
This may be a little too specific, but does anyone know of a salvage yard in Houston that deals in Miata's, NB's ? Thanks.
December 3rd 06 05:17 AM
by Chris D'Agnolo Go to last post
3 480
Is the alternator the first thing to go at 120K? by Chris Rennix
I've had a wonderful Miata experience since 1999. I've not had a single mechanical thing go wrong. I did replace the weatherstripping at around 30K and I've had my share of poor mechanics at the multi-car dealerships. You know, the ones that have a special Mazda desk to make you think that...
December 3rd 06 05:15 AM
by pws Go to last post
8 407
The Japanese car and parts can be bought very cheaply. by japanvehicle
Dear everyone, Thank you for reading our email. We want to inform you of the method of buying a Japanese car and parts very cheaply. Please contact us by E-mail.
December 2nd 06 05:18 AM
by japanvehicle Go to last post
0 489
conflicting info engine removal by peter
hi, i am getting back to my 95 engine job and after specking to mazda, they say to pull the tranny out first and that the saddle does not need to be removed. i am sorta confused as how to procede. any comments/suggestions? thanks, peter
December 1st 06 08:41 PM
by peter Go to last post
2 242
Engine Managment Diagnostic Solutions by Daz Ellerington
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&ih=011&sspagename=STRK%3AMESE%3AIT&viewitem=&item=320056544252&rd=1&rd=1
December 1st 06 05:56 PM
by Daz Ellerington Go to last post
0 404
RX-7 Complete Brand new Gasket set up for grabs on ebay starting at £100 by Daz Ellerington
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=320054308723&ssPageName=ADME:L:LCA:UK:11
December 1st 06 05:52 PM
by Daz Ellerington Go to last post
0 354
Post New Thread


Display Options
Showing threads 1301 to 1320 of 2964
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:53 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.