|
|
transmission pan gasket question by
Nate Nagel
I've got a '55 Studebaker with a '63 Borg-Warner Flightomatic
transmission installed in it. The pan gasket is leaking badly and
making a mess of the floor of my friend's garage. If I ask for a pan
gasket for a later Ford FMX (same tranny) at the parts store, would it
be neoprene instead of...
|
|
6 |
585 |
|
|
1989 ford f-150 start troubles by
Swabbie
this is a problem that has plagued this truck for about 2 years now. I have
posted this problem on about every ford tech site on the net. Still no go.
heres the situation,
the truck will crank right up, and drive perfectly to wherever I am going. I
then turn it off.
If it has been about 30 miles or...
( 1 2)
|
|
17 |
1,319 |
|
|
98 ford windstar keeps stalling by
Swabbie
this happens about once a week.
heres the kicker, it only stalls from a stop while making a right turn.
I'm sure this is a coincidence, but everytime it has happened, its during a
right turn from a stop sign.
If you drop it into neutral to restart it, it won't.
you have to completely stop the van,...
|
|
0 |
487 |
|
|
scan tool by
mbjj
What kind of scan tool should I get for my '94 metro? I know that OBD 2
started in '95 and looking at the interface under the dash has me a little
confused. I want to pull the codes and have a couple of other
troubleshooting measures at hand if needed. Is there a digimoto type thing
that I can...
|
March 14th 05 09:24 PM
by mbjj
|
0 |
417 |
|
|
Fender bender problems? by
Son of Sam
Hello gents. OK...93 Cavalier RS. I was driving downtown in some
fairly heavy traffic the other day and I hit another car from behind.
The guy in front of her slammed on his brakes, so she slammed on hers
and I ran into her. The problems that I have that I can see a
-hood won't close...
|
|
0 |
382 |
|
|
Stretch & retemper "tired" springs. Can-do? No-go? Insane? by
Don Bruder
Subject pretty much says it all.
Wondering about trying to do this with the springs from my '82 Mazda 626
that has a touch of "saggy" to it. The concept in my head going
something like "anneal, stretch, retemper."
If practical, anybody got any ideas about who to talk to in the northern
California...
|
|
8 |
624 |
|
|
|
March 14th 05 03:57 PM
by D J O
|
0 |
396 |
|
|
Question about half shafts / CV boots by
[email protected]
While doing some other work on my car, I noticed that there was play in
in my halfshaft. I could grab the part between two of the accodian
looking boots and could move it back and fourth (towards either boot).
Is this normal? Does it make it bad? The boots themselves look fine
(not torn). ...
|
|
3 |
617 |
|
|
Costs more to mount/balance ultra high performance tires? by
[email protected]
A mechanic told me that it would cost more to mount/balance my GoodYear
F1 GS-D3 tires than the other regular times. He said it is more
difficult to balance these ultra high performance ones. Is this crap or
is he legit? I thought mounting and balancing is pretty much the same
for all tires. Thanks.
|
|
2 |
673 |
|
|
|
March 14th 05 02:30 PM
by TJ
|
0 |
1,700 |
|
|
|
|
0 |
572 |
|
|
Hub and disc assy doesnt go back far enough by
wortho
I am in dire need of assistance as I have changed my bearings and repacked
the hub with grease and trying to install the disc assembley back onto the
stub axle, but it seems as though it is not going back far enough to allow
the calipers to fit on.
The car is a FJ40 Landcruiser 1976 and I am...
|
March 14th 05 12:58 PM
by HLS
|
5 |
351 |
|
|
Oldtimer Gallery by
Thomas Schultz
Hi,
i would like to show you my Photogallery with some nice Pictures
of oltimer car and trucks.
Cars:
http://www.th-schultz.de/gallery/view_album.php?set_albumName=album33
Trucks:
|
|
0 |
532 |
|
|
Does windshield rock chip repair prevent crack propagation? by
mike
Got a nasty rock chip in my windshield. Three impact divots connected
by a crack about 1.5" long. Short star pattern at each impact.
It's well out of the normal field of view, but I'm very concerned about
the crack propagating.
Googling informs me that the rock chip repair people are good at...
( 1 2)
|
March 14th 05 05:09 AM
by
|
18 |
1,401 |
|
|
Popping suspension sound.... by
[email protected]
I have an 87 S10 4wd pickup. It has been making a popping noise on the
front driver side. I'm pretty sure something is worn in the suspension
because my front left side tire (the one on the driver side) is worn on
the outer portion of the tire. Does anyone have any ideas which part
on the...
|
|
2 |
300 |
|
|
broke the bleeder screw by
[email protected]
Hi out there, I think there was a little air in my brake lines, and
when I went to bleed the brakes one of my screws broke off, just about
flush with the caliper. There is no leakeage of brake fluid, but I
want to get that screw out and put in a good one. I got one from the
junkyard. Does anyone...
|
|
9 |
1,053 |
|
|
Anyone know Web site with Detailed OBD 2 Code details by
Mountain
I was wondering if anyone knows of a web site that has detailed
interpretation of OBD 2 codes. I have found many sites that list the
one-liner title of the code, but was hoping there would be some that
would give a paragraph or so on details of how to address the issue of
the code. I found one a...
|
|
0 |
513 |
|
|
Need explanation for computer code for '93 Camry by
[email protected]
I have a '93 camry v6 that has a check engine light. When I go through
the procedure to get the computer code, it gives me one not listed in
the book!
I get a 28. The last code in the group listed in the Haynes manual is
27. Most of the 20s list problems with the oxygen sensors. This car
must...
|
|
1 |
358 |
|
|
Tirerack vs. Discount tires by
[email protected]
>From my research and quotes that i've gotten, discount tires come out
to be cheaper for the tires that i wanted. Alot of people have talked
about tirerack, but the cost was more than discount tires. Just wanted
everyone to do research before jumping on the tirerack bandwagon.
|
|
3 |
613 |
|
|
Toyota Paseo starter by
Paul
Can someone tell me what to disassemble to get the starter out of a '92
Paseo. I have it loose, but cannot see what will work for getting it
out. I am told the car may be similar to a Celica. Thanks, Paul
|
March 13th 05 09:50 AM
by Paul
|
0 |
266 |