|
|
Test by
Adrian Gruber
test
|
|
0 |
273 |
|
|
Faded Striping by
Adrian Gruber
Hello all, I am new to this user group and have owned Mustangs since 1980.
I have a problwm with a 2002 Mustang GT which I need some advice on.
I have a Oxford white GT with Ford Market and "After Market " Striping on
the hood.
The after market striping is vinyl and is starting to dis-colour and...
|
March 2nd 05 11:02 PM
by Spike
|
1 |
456 |
|
|
ok round 2 on the 99 Cobra by
Defiant
well I've got a second chance on the 99 Cobra.
went and drove it this morning and I must say I'm impressed with the car, it was tight, reasonably fast and rattle and squeak free. here are the mods done to it, true duals, flowmasters, K&N, nothing else that I could find. pulled hard all the way to...
( 1 2)
|
March 3rd 05 02:03 AM
by Rein
|
13 |
863 |
|
|
stang in new Consumer Reports by
Itsfrom Click
The auto issue of Consumer Reports arrived today (all sorts of charts,
comments to memorize!)...
in article on owner satisfaction (as derived from J D Powers
complaints per 100 cars sold) the 2004 Mustang is rated as the most
reliable US built car for 2004 "on a par with the Honda Accord...
|
March 3rd 05 02:05 AM
by Rein
|
3 |
781 |
|
|
Sleeper Identification by
CobraJet
Here's a repost of something I wrote in the Big Block group in 2000,
since Patrick brought up the word "sleeper". Perhaps some of the old
timers here will get a grin:
15 Tips for Sizing Up the Street Sleeper
1. Caked-on dirt covering tire brand on sidewalls:
Sneaky - Goodyear or...
|
|
0 |
484 |
|
|
|
|
21 |
1,503 |
|
|
1953-62 FORD ENGINE/CAR ID WALL CHART-312w2-4's,406w3-2's by
[email protected]
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7959028827&rd=1&sspagename=STRK%3AMESE%3AIT
ORIGINAL FORD DEALERSHIP WALL CHART, WITH ENGINE/CARB/VIN PLATE ID,
COVERS ALL CARS AND TRUCKS 1953-62 WITH SPECIAL CENTER SECTION FOR
THUNDERBIRD
SOME SPECIAL HIGH PERFORMANCE ENGINES LISTED...
|
|
0 |
590 |
|
|
Turn signal switch problems in '97 Cobra... by
JS
Anyone know where to get ahold of a turn signal switch (multi-funciton
switch) for a '97 Cobra? I believe the switch is the same as the GT's
switch would be. Mine's dying a slow and painful death (RH turn signal
functions about 30% of the time) and I'd like to pull it before I have no
headlights...
|
|
9 |
894 |
|
|
Rear seatbelts - 1965 Mustang by
MJT
Any advice on where I can find seatbelt anchors for the rear seat
(convertible)?
I read that rear belts were optional at the time, and required a dealer
installed seat belt anchor, but haven't been able to find anything on the
net. Any advice or source you can point me to would be...
|
|
2 |
598 |
|
|
Ford Racing Mustang GT Wins At Daytona by
351CJ
With less than one day's experience behind the wheel of his new Ford
Racing Mustang GT race car, car owner and driver Tom Nastasi, with
co-driver Ian James, claimed victory in the opening race of the 2005
Grand-Am Cup season at Daytona International Speedway. The win marks the
first race and first...
( 1 2 3)
|
|
22 |
1,345 |
|
|
Slow 1/4's for the 05's?? by
tony kujawa
14.25-14.50??
Read this post from the camaro.firebird ng. NO, I'm not trolling, and this
guy may be BS'ing, but have any of you seen or run your '05 at the track?
If I'm going to get smoked by an LS-1, I have no interest in a new GT. I'll
go get a 98-02 T/A.
> Last Wednesday, Feb 2, was opening...
( 1 2)
|
March 4th 05 06:59 PM
by 351CJ
|
14 |
906 |
|
|
1965 Mustang PS Conversion by
Chris
Hi,
Trying to convert my 65 Mustang from Manual to Power Steering. Does
anyone know if the Steering Box needs to be changed? Or do I just
need the Control Valve and Slave Cylinder?
Thanks
( 1 2)
|
March 4th 05 10:23 PM
by Spike
|
14 |
1,561 |
|
|
|
|
12 |
1,131 |
|
|
Free stuff in Atlanta by
Mamushka
Cleaning up the garage so I'm getting rid of some stuff, first come
first serve No Shipping must pick up.
89 GT stuff
-Cats (with pipes) off of 89 GT, 88K miles on them, passed emissions
last time car was checked. Use them as is or gut them for a set of
cheap off-road pipes.
-89 gas tank, no fuel...
|
|
0 |
795 |
|
|
69 fastback drivers window by
[email protected]
The drivers window rolls up far past point that it hits beyond the seal
and is causing it to chip the window. Not to mention that its not
sealing properly with the quarter window. I know there is a adjustable
stop device but once the window is completely rolled up there is still
about a 1/4in gap...
|
|
1 |
923 |
|
|
Trunk floor replacement by
JohnnyK
Dealing with a 67 fastback here, and just wondering ifit's possible to
replace the trunk floors without taking everything else out. Looks like
it has to slide under a large bracket that braces the front of the
quarter panel to the roof, and then tuck under the inner wheelwell.. Has
anyone done this...
|
|
0 |
278 |
|
|
Boss F-150's by
Nicholas D
Is anyone familiar with Boss F-150's? Are they legitimate? Is this Ford
authorized and does it have a factory warranty? I just saw a few on EBay for
sale so I figured I'd ask. Thanks in advance.
-Nick
|
|
0 |
368 |
|
|
Mach 1000 head unit removal... by
BigRandy
I'm trying to install an aftermarket headunit but I need help removing the
factory Mach1000 head unit. Can anyone help?
( 1 2 3)
|
March 6th 05 02:35 AM
by
|
24 |
1,625 |
|
|
Bringing it back to life by
Jay Honeck
I've had my 2000 Mustang Convertible in the back of our unheated hangar
since last November, untouched. I covered it with cotton sheets, filled the
gas tank to the top, aired up the tires -- and haven't touched it since.
Yesterday I charged the battery up and fired it up. The engine sounded...
|
|
4 |
780 |
|
|
FS: 6 Cyl airconditioning brackets by
DellDude
I have a pair of 6 cyl brackets for mounting an air conditioning compressor,
one is NOS. Plus I have the two stablization brackets and one wire clip
used to mount the original type compressor. The main brackets have a C9
part number.
They should work for a years 6 cyl. The one set of brackets I...
|
|
0 |
400 |