|
|
JDM F20a Engine Question. by
hamwitty
Hello,
Does anybody have any info of the JDM F20A engine swap for a F22A on a '92
Accord?
I hear that this is a direct engine swap, but I need more info to be
clear.
Is everything a direct bolt on? And does the F20A share the same part
numbers i.e. spark plugs, gaskets, timing belt, etc?
|
|
5 |
1,023 |
|
|
|
|
1 |
1,327 |
|
|
car won't start by
scoutdad
My son has a '93 Accord. It has a starting problem that seems to only
occur in the morning. Each morning when he goes to start the car, he puts
the key in and nothing happens. The motor doesn't turn over, the dash
lights and radio don't come on, but the interior lights come on and the
headlights...
|
November 7th 04 08:37 PM
by remcow
|
1 |
483 |
|
|
Integra Emissions Failure by
Dkakd
My 1990 acura integra did not pass Virginia emissions due to high CO2 at 25
MPH. I think limit was 80 PPM and it tested at 140 PPM. It has news plugs,
clean filters, and 173,000 miles.
Is this a simple mixture adjustment? Thanks,
Dan
( 1 2)
|
|
13 |
2,878 |
|
|
Want to Buy - 96-00 civic speedo cluster in km/h WITH TACHOMETER by
disallow
Hi there,
I am located in Winnipeg, and would like to put a factory
cluster in my 98 civic LX that has a tach, as opposed to
the bare bones cluster I have now. I know, I know, I
should have just bought a car that came with it, but hey,
we all make mistakes, and I like my car, I just want it
to...
|
|
0 |
724 |
|
|
|
November 8th 04 03:04 PM
by MAT
|
0 |
947 |
|
|
Stupid Americans! -- Stupid... Stupid... STUPID!!!___________ mixqec by
indago
041107 1001 - Christopher Wall posted:
> Well, I tried to decide who to vote for. That was tough-- a president who
> lies, cheats, steals and makes money off of the backs of the people, OR, a
> president who can't decide whether to lie, cheat, or steal off the backs of
> the people. So, I did the...
|
|
3 |
1,820 |
|
|
How can I modify 2004 pilot rear 12v outlet to unswitched by
Craig M. Bobchin
Hi all,
I have an '04 pilot, and would love to be able to use the rear 12v power
outlet without having the ignition switched on. Is there a computer
setting or fuse I can remove to accomplish this?
When I'm camping, it is sometimes a pain to have to keep the car on and
I would love to be able to...
|
|
3 |
1,122 |
|
|
93 Civic Door locks by
jstc
The auto door locks on my sons 93 Civic quit working.. We checked the
fuse and it was fine. What else should we check?
|
November 8th 04 09:53 PM
by jstc
|
0 |
553 |
|
|
Enable DRL on 2005 US Spec CR-V? by
RWM
Is there an OEM relay, say from a Canadian spec CR-V, that can enable a
DRL function on a US spec car?
How about best aftermarket kit to burn the high beams at reduced voltage
as DRLs?
Thx.
- RWM
( 1 2 3 ... Last Page)
|
November 8th 04 10:01 PM
by RWM
|
57 |
3,260 |
|
|
99 Accord V6 Transmission hesitation by
lcmon
My 99Accord V6 rough shifting getting worse , hesitate on
both up & down shift . I knew this Honda trans does not shift
very smoothly. Does anyone know what is the fix ?
Is there a TSB out from Honda on the problem ?
ThanX
|
November 9th 04 03:27 AM
by Keith J
|
1 |
553 |
|
|
Ignition wont start car by
oeasm
Hello, I have a major but simple problem that I can't figure out.
Thieves tried to steal my car an 1984 honda prelude. They were not
successful, but they messed up my ignition switch. Now every-time I
turn my car on I have to make sure that I don't leave the ignition on,
therefore, I need to move...
|
November 9th 04 03:33 AM
by remcow
|
1 |
1,151 |
|
|
Civic front strut installation by
John Clavin
I had some new dampers/shocks installed in the front struts on my '98 Honda
Civic a few months ago after fighting with tire wear problems, mostly
cupping. The dealer was no help on this and thought it was just bad tires
(Michelin X-One's). So I had some KYB GR-2s installed at a shop I...
|
|
1 |
778 |
|
|
igniter testing by
jim beam
finally, i've run a test on the old igniter unit for my civic. i wanted
to do this out of the car, so the procedure described below is an
additional test option if you have the pieces in your hand rather than
still in the vehicle.
thanks to the information provided by you all, particularly graham...
|
|
3 |
826 |
|
|
Acura CL Passenger Door Lock Actuator by
Spiderman
I want to remove the power door lock actuator on a 1997 Acura CL. I've
removed the door panel and can't figure it out...it appears the latch and
actuator are part of the same assembly. What's the trick?
|
November 9th 04 10:15 PM
by TCS
|
1 |
544 |
|
|
Beware of Metro Honda RI! by
Al Andre
Hello everyone,
I went to my dealer, Metro Honda in Rhode Island, and I can tell you that it
has been one problem after another. From loosing my appointment to being
discourteous, to causing problems and then not being able to undo what they
caused. They actually argue with me when I am right at...
|
|
2 |
547 |
|
|
99 Accord Check engine light and codes by
Mike Wright
The check engine light came on on our 99 Accord V6 which has an auto trans
and about 101000 miles. Jumperering the DLC connector returned 8 flashes,
all the same duration which means either P1359, 1361 or 1362. These codes
are CKP/TDC sensor disconnection or TDC intermittent or no voltage. ...
|
|
0 |
1,765 |
|
|
Tweaking 04 CR-V alignment by
Nobody
Just had an alignment done. Rear toe is .07/.09 which is fine. Dealer set
left front toe to 0 which is what it should be and the right front toe
-0.01 for some reason. As minor as this may seem, I can feel it. A little
too loose for me and a it's little twitchy on the highway...not...
|
November 10th 04 02:48 AM
by Nobody
|
0 |
1,151 |
|
|
frame rust--how to fix? by
Abeness
I know absolutely nothing about body work, though I've used a sanding
disc and wire brushes before. I have rotary brushes for my drill, too.
I've got a bit of rust on the frame column between the front and rear
doors on the driver's side, around where the passenger door hinges
attach to the frame....
|
November 10th 04 04:32 AM
by Abeness
|
5 |
1,069 |
|
|
|
|
0 |
824 |