A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Corvette Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
defroster-air conditioning question by Scubabix
When I'm using my a/c in my 96 coupe,(in Florida most of the time) I get condensation on the windshield over the defroster vents. There is cold air coming out of the vents. Is it possible the defroster flap ( or whatever it's called) isn't shutting the flow off completely when turning on the...
August 21st 04 05:38 PM
by Don B. Go to last post
5 885
69 Engine VIN # help by Mike Bradford
Where exactly are the VIN numbers located on the engine for a 69 350 small block corvette? Can they be viewed without removing any engine parts? I don't know if I have the original engine. Any help will be appreciated.
August 22nd 04 12:42 AM
by Tedd Riggs Go to last post
1 665
Is there a CarFax type of service for pre-1981 vehicles ??? by [email protected]
CarFax says they only go back to 1981. Is there a Service that goes back before this ? Thanks, Dave
August 22nd 04 01:22 AM
by Tedd Riggs Go to last post
1 895
Early C3: 4 X 6 Delco replacement speakers - 10 Ohms or not? by pgtr
I've found some 'Delco' service replacement 4X6s available thru GM as well as possibly some mail-order outfits claiming to be 'original replacements' or service replacements. Q: Anybody tried these or have personal experience or knowledge? Q: Are they in fact 10 ohms since they claim to be...
August 22nd 04 04:12 AM
by pgtr Go to last post
2 1,331
Measures by Catman
Bob I wrote: > You stupid ignorant zipperhead, this has nada to do with any of the NG's So you top posted it back to all of them? Way to *GO*. > > George Hill wrote: >> The biggest shocking news on Earth >> ----------------------------------
August 22nd 04 03:11 PM
by Catman Go to last post
0 946
"Gift" for Diode and Ric by Tedd Riggs
Two classics <g> http://www.albinoblacksheep.com/text/bushmail.html# http://funny.ansme.com/politics/bush/build.html -- Tedd Riggs Redmond, WA
August 23rd 04 07:07 PM
by Dad Go to last post
4 1,969
Error code 36 by Rick B.
I checked the error codes on my 1987 coupe (thanks to the help of you guys) and received code number 36. Much to my confusion, I was given two different meanings for that code. One from the www.c4vettes.com website said code 36 is the mass air flow burn off circuit, meaning a problem with the...
August 24th 04 02:30 AM
by Dad Go to last post
2 2,024
1994 Leather Sport Seat replacement by Charles L. Cotton
I have a '94 Cpe with sport seats I drive to the office every day. It has 143,000 miles on it and the red leather sports driver's seat is starting to look a little faded. The leather is structurally sound, just faded. There is a zipper on the back of the seat back, so it may be easy to remove. ...
August 24th 04 03:07 AM
by Charles L. Cotton Go to last post
7 2,007
C4 brakes and rotors by [email protected]
Could someone help me out with an estimate to replace all 4 pads a rotors on a 1996 C4. I've gotten estimates from $1100 to $1600.
(Multi-page thread 1 2)
August 24th 04 07:29 PM
by Diode Go to last post
11 1,880
where can I get an 04 shop manual by x
Can someone tell me where I can buy a GM shop manual for my 2004 Corvette? I'd like it on CD if possible. Thanks, Mike
August 24th 04 10:04 PM
by Jon Go to last post
6 1,598
do it jose by sotplo
Its at the beginning now.its like buying a lottery ticket http://DollarRandomizer.com/?sotplo67 Bye
August 25th 04 12:04 AM
by sotplo Go to last post
0 899
Overheating problem by lkitesplit
I was hoping someone might have an answer for me. I have a 94 coupe with 66k miles. It runs just fine on the open road, but gets pretty hot while standing still or in traffic. The water pump was changed recently and the radiator fluid is pretty clean. What do I do? John
August 25th 04 02:28 PM
by lkitesplit Go to last post
8 1,025
C4 cooling by [email protected]
I need some help. 1990 c4, temp is good when driving but when idling the temp begins to rise and almost overheats. No leaks, replaced all seals and gaskets, changed thermostat. Water pump appears to be working but not well, no leaks from weep holes. Is the pump starting to fail but no symptoms?...
(Multi-page thread 1 2 3)
August 25th 04 04:44 PM
by Diode Go to last post
29 2,318
Intake Manifold Recommendation - Torker? by [email protected]
Ernie, I have a 1970 454 . I used to have the Torker on it and its better than the stock manifold . No problem on hood clearance. But, i found the warmup characteristics of it not too good. Once the engine is warmed up, its fine. The Torker is a Single Plane manifold as you might know, and is...
August 25th 04 06:07 PM
by ken Go to last post
7 1,434
FS: '74, 454 Full RestoCoupe, 4 spd, 4" sidepipes, CA by Wavslav
Price? Dirt Cheap. $15,500 I think it could sell for closer to $20K but I don't have months to wait for the price, It's time to go. Thanks Evan >
(Multi-page thread 1 2)
August 25th 04 06:12 PM
by Dad Go to last post
11 2,456
84-89 Digital Bulb Replacement by n
On Tue, 24 Feb 2004 18:24:23 GMT, "Mike" > wrote: >In >, "Black Bomb" > writes: >>Hi, >> >>I've been having to tap on my dash at times to get 1 or 2 bulbs to turn on >>unless I wait & hit a bump instead. I would like to...
August 25th 04 08:27 PM
by Black Bomb Go to last post
3 1,265
Do I need to change the speakers in my 04 ,when installing a new radio ? I was thinking about puting in The eclipse navigation/dvd/cd/radio all in one unit but wanted to leave the bose speakers in by Tommy*
http://www.eclipse-web.com the model number is AVN 2454 its is a double din ,so it should be a perfect fit Thanks in advance
August 25th 04 09:29 PM
by Vette88 Go to last post
2 1,481
Help Needed: Thumping Noise From Rear Wheel by Fred
<<What does this sound like to you........U-joint problem in the axle driveshaft?>> ------------------ If the axleshaft becomes harder to turn at 180 degree intervals, then the problem is probably not a U-joint since the U-joint does not rotate at the same rate as the axleshaft. I wonder if you...
August 26th 04 04:08 AM
by Sting Ray Go to last post
5 877
Question about pads and rotors on ebay by [email protected]
Reposting as people probably thought this was an add based on original subject line: Does anybody have any recommendations or comments to make rotor/pad deals on ebay? They have some great deals on pads and rotors for my 96 C4 - approx $200 +/-. for a set of all four. (erotorshop, etop line, US...
August 26th 04 11:13 PM
by BenF802961 Go to last post
4 1,045
FA: 1997-2004 Corvette C5 Flags Rear Emblem by aRKay
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7918637885 This eBay auction item number 7918637885 is for a new (sealed package) General Motors rear emblem for a 1997 to 2004 C5 Corvette. I purchased two and only need one. The GM part number is 10258165 and the package says...
(Multi-page thread 1 2)
August 27th 04 03:53 AM
by aRKay Go to last post
10 2,923
Post New Thread


Display Options
Showing threads 61 to 80 of 3896
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:18 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.