A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
'92 3.3L Olds Cutlass Ciera, intermittent code 42, bad stumbling by [email protected]
1993 3.3 Old Cutlass Ciera S code 42 Slow acceleration,SES,Shuts off
Yesterday 05:40 AM
by Bill Vanek Go to last post
1 24
Mazda tribute, 6 circuit codes by [email protected]
I have a 2005 Mazda Tribute 3.0. About a month ago I had the engine light come on, I immediately checked the codes. p0443 ( Purge valve solenoid ) p0403 ( egr solenoid ) and all 4 o2 sensors p0 135 141 155 161. ( o2 heater circuit ) All 6 codes are electrical circuit related. I have checked...
June 21st 18 11:01 PM
by dsi1[_11_] Go to last post
8 16
Tesla. by [email protected]
jimstone.is Internal company sabotage at Tesla
June 19th 18 06:58 PM
by Heron[_2_] Go to last post
1 8
diesel-pentane blend to reduce emissions? by [email protected]
Diesels seems to be on the way out. Not only because of cheating, but also the issue of diesel particulate filters being ****ed up by urban driving patterns, with expensive replacement jobs. I can only find one journal paper about diesel-pentane blend which reported up to 18% reduction in NOx...
June 19th 18 09:14 AM
by [email protected] Go to last post
0 6
June 17th 18 01:27 PM
by [email protected] Go to last post
1 19
I used to buy tires from TireRack - now SimpleTire (how can they do it?) by Jonas Schneider
For years, I have been buying tires from TireRack, opting to mount them and static balance them myself at home. This week, I called TireRack, to order a set of four passenger tires, where I picked a traction A, temperature A, and treadwear 400 tire, with load range 99 and speed W, where the price,...
(Multi-page thread 1 2 3 ... Last Page)
June 16th 18 08:51 PM
by [email protected] Go to last post
46 389
Difficult starting by Ivan Vegvary[_2_]
2008 Kia Rondo, V6 Starts in an instant EXCEPT when at gas station for a fill up. Takes over 30 seconds of cranking, stalls 2-3 times and runs crappy for about one minute. Very repeatable. Is the gas cap part of the computer system? Thanks for advice.
May 29th 18 09:13 PM
by [email protected] Go to last post
6 20
BB 366 - rockers clatter; oil pressure but no oil at rockers by [email protected]
Hi - I'm working on my farm's chevy 87 c-70 w/ 366 v8 (which came out of an early 1970's era truck). The motor runs and has good oil pressure (according to the gauge) but there is no oil coming out of the pushrod tubes and the valves are very noisy as a result. What would cause this to be? There...
(Multi-page thread 1 2 3)
May 24th 18 05:18 PM
by Gerald Pate Go to last post
26 221
Are you a Prepper? by [email protected]
preppersgab.com A working vehicle could be the difference between life and death once an EMP event strikes: Top 10 vehicles for your EMP survival
May 23rd 18 07:31 PM
by dsi1[_11_] Go to last post
8 23
Why need to turn new brake drums?! by Scott Dorsey
In article >, > wrote: >On Friday, March 5, 1999 at 2:00:00 AM UTC-6, Michael Shell wrote: >> Years ago I bought a new set of rear brake drums for my early 1970's >> Ford. After the brake job I noticed a vibration when...
May 22nd 18 05:01 PM
by Scott Dorsey Go to last post
0 22
Alternator connector glowing red hot after jumping veh with other battery by [email protected]
My 99 Explorer had been running fine. Tonight I left my lights on, killed the battery - which is about a week old from Walmart. Boosted it with another battery I have that happens to be good. Car fired up but the connection nut with the rubber boot at the top of the alternator started glowing red...
May 18th 18 02:30 AM
by [email protected] Go to last post
6 32
Ford F150 Rotor installation problem by Michael[_23_]
I took the rear driver rotor off my truck and was ready to replace it when a piece of the emergency brake shoe broke off (a wood-like substance that's like a shim about 1/8 or less). I'm need to travel miles tomorrow and I'm wondering if this is going to screw up my brakes if I just install the...
May 13th 18 07:52 AM
by dsi1[_11_] Go to last post
3 32
How to refill a leaking Sam's club "Michelin" floor jack by Comboverfish
Way back when, in one or more newsgroups, I suggested the blue 3.5 ton quick rise jack as sold by Sam's Club, to those who were looking for a cheap, functional, and strong floor jack for home use. I wanted to offer some tips I recently discovered when confronted with the problem of fixing or...
(Multi-page thread 1 2)
May 11th 18 04:00 AM
by [email protected] Go to last post
17 4,439
Can I replace my 185 tires with 195? by [email protected]
I had to have one bad so I let them replace my 185 with a 195 and I'm back the next day my car pulled horribly to that side and jumped all over the road so I wouldn't try it unless you know for sure
May 11th 18 02:57 AM
by [email protected] Go to last post
3 73
Fuel pressure issue - 95 Astro - please help by [email protected]
Can someone please help me figure this out? I am really stuck. I have a 1995 CHEVROLET TRUCK ASTRO VAN 2WD 6 Cylinders 262 W 4.3L CPI. 105,000 miles Symptoms: The van is cutting out like it is running out of fuel while driving.
(Multi-page thread 1 2 3 ... Last Page)
May 10th 18 03:18 AM
by Drewsky Go to last post
58 843
May 8th 18 11:09 PM
by dsi1[_11_] Go to last post
1 42
windscreen affecting airbags? eh? by [email protected]
I saw an advert from an auto windowscreen company claiming that if you windscreen is not fitted properly, it might affect airbags deployment. How so?
May 7th 18 04:42 PM
by Steve W.[_6_] Go to last post
3 64
May 6th 18 07:03 PM
by Sanity Clause[_3_] Go to last post
1 40
S10 2.2 lifter noise? by BOB URZ
I had previously posted last year on the problems i had with my 96 2.2 Chevy S10. To recap, the tensioner on the cam chain broke and allowed the chain to jump time. I took the head off and found 8 bent valves. I had the head into a machine shop, had it cleaned, decked, and 8 new valves and seals ...
May 2nd 18 01:18 PM
by tonysimpkins1 Go to last post
5 180
Hydraulic Floor Jack, Release Valve won't tighten by Gifters
OK, I'm trying to fix my Floor jack, the problem is when I tighten the handle it doesn't come to a stopping point, the handle keeps turning and the release valve is left open, I've first couple of parts and now there is a square hole and I assume a ball barring, I have no idea what do do from...
April 28th 18 06:43 PM
by [email protected] Go to last post
3 1,847
Post New Thread

Display Options
Showing threads 1 to 20 of 16720
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 01:52 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 AutoBanter.
The comments are property of their posters.